How do I setup and run a macro in the current
version of GibbsCAM?
Click File --> Macros --> Configure to open the Macros configuration
Select an empty unused slot to add a new macro to the list or a
currently in use slot to modify or remove a previously setup macro.
Click on the Browse button to open the Select Macro File dialog and
navigate to the location on your computer containing the macro you
wish to setup. Select it and click Open.
Verify the information is correctfor
the Name and path boxes located at the bottom of the dialog and
press the Update button to load the macro into the slot you
previously selected. When you are finished loading macros into the
list, press OK to close the dialog.
Click File --> Macros again, but this time you should see your newly
setup macro(s) in the list.